Plygene gutterline surveying and fitting guide

Under the existing roof sheet

Liner fixed behind existing eaves flashing

Liner fixed behind new flat plate flashing

Liner fixed to underside of roof sheet

Option 1 - Where the insulation is flush with the gutter edge

Option 2 - Where the insulation overhangs the gutter by >40mm

Option 3 - Where the insulation is set back from the gutter edge

Where the existing flashing can be removed (preferred method)

Turnback method (minimum 70mm overhang) - if the flashing cannot be removed

Option 1 - Pre-overclad (preferred method)

Option 2 - Post overclad

Option 1 - Where existing eaves closure can be removed

Option 2 - Where existing eaves closure cannot be removed

Option 3 - Where eaves closures are not present

Behind existing wall flashings

Trapping the liner under existing cap flashings

Behind uninsulated panel

Behind insulated panel

Fixed through insulated panel

Standard outlet

Standard stop end

Moulded sole outlet

Moulded stop end

Moulded stop end with weir

Moulded stop end with outlet

Moulded stop end with outlet and weir

Moulded side/sole outlet

Sump box complete with outlet

Side box complete with outlet

Full side outlet

Side sump box complete with outlet

Gutter transition

Gutter step

Discharge flange

Moulded corner

Moulded full tee piece

Moulded half tee piece

Moulded emergency overflow

Moulded side chute

Back to back moulded stop end cover unit

Moulded letterbox weir / moulded open top weir