Moulded components

General guidelines that should be followed when installing all moulded components are as follows:

• Ensure the area where the component is to be installed is clean and dry. Blow dry with heat gun if damp
• Firmly press the liner into the gutter creases. This will prevent air pockets and form a solid base to weld the stop end to the liner
• Always use the 200mm rule (the liner should be pinned every 200mm across the gutter sole and up the gutter slopes if required)
• With the heat gun tack weld the component into place ensuring the location is correct before a full weld is employed
• The weakest point of any weld is the crease lines on the gutter sole
• Allow the component to cool before probe testing the weld
• Any un-welded areas will need to be re-welded and again probe tested once cool