Moulded sole outlet

• Ensure the gutter around the outlet hole is clean and dry. Blow dry with heat gun if damp
• Continue to roll liner two metres beyond the sole outlet
• Pin the liner around the sole outlet hole. Outlet size will determine the quantity of fixings required
• Ensure Sharmans Fixing Caps are installed over all fixings prior to welding
• Using a Stanley knife, cut around the sole outlet removing the section of liner ensuring the full outlet capacity has been achieved
• Push the moulded sole outlet through the hole in the liner ready for welding
• With the heat gun tack weld the flange on the sole outlet into four quarter sections forming pockets
• Fully weld all four pockets to the liner
• Allow the sole outlet to cool before probe testing the weld
• Any un-welded areas will need to be re-welded and again probe tested once cool