Bespoke moulded stop end c/w weir overflow
Format: pdf
Bespoke moulded stop end c/w weir overflow (MWSEOF)
Before hot air welding of the stop end, the liner should be pinned and fixed.
Once hot air welding is complete, the angle is blank pinned and fixed.
Fixings specification engineered for gutter substrate type
| Substrate | Product Code | Pilot hole (if required) | Drill speed |
| STEEL < 3mm | HDS-LS-30 | N/A | 0-2000rpm – Can be full speed |
| STEEL > 3mm | HDS-HS-40 | N/A | 0-2000rpm – Can be full speed |
| CONCRETE | HDS-CON-45 | 5mm Diameter | 0-950rpm – Typically 750Watt |
| ASBESTOS | HDS-ASB-38 | 9.5mm Diameter | Set to lowest speed |
Please refer to the current health & safety guide health & safety guide when drilling holes in highly bonded materials, including asbestos cement.
For a typical installation, as illustrated, the two fasteners at the end require washers and the four in the gutter don’t.
The ‘200 rule’ should always be adhered to when determining how many fixings are required in the pinning region.
The 200 rule
The maximum gap permitted between fixings within the pinning region is 200mm.
For example, one additional fixing would be required for a 300mm gap between fixings, to bisect at 150mm, while two additional fixings would be required for a 600mm gap – one at 200mm and one at 400mm.
Order your bespoke moulded stop end c/w weir overflow
This item has been developed to discharge water from the end of the gutter if it becomes full and is an essential part of many Plygene gutterline systems.
Download and complete the attached PDF to order your required quantity, quoting the job reference, quantity needed and project dimensions.
Function: To discharge water from the end of the gutter if it becomes full
Type: Datasheets
