Bespoke moulded sole outlet
Format: pdf
Bespoke moulded sole outlet (MWO)
The liner should be pinned and fixed prior to hot air welding of the sole outlet.
Fixings specification engineered for gutter substrate type
| Substrate | Product Code | Pilot hole (if required) | Drill speed |
| STEEL < 3mm | HDS-LS-30 | N/A | 0-2000rpm – Can be full speed |
| STEEL > 3mm | HDS-HS-40 | N/A | 0-2000rpm – Can be full speed |
| CONCRETE | HDS-CON-45 | 5mm Diameter | 0-950rpm – Typically 750Watt |
| ASBESTOS | HDS-ASB-38 | 9.5mm Diameter | Set to lowest speed |
When drilling holes in asbestos cement and other highly bonded materials, remember to refer to the current health & safety guide.
Unlike other bespoke moulded units, the ‘200 rule’ – requiring a maximum permitted gap of 200mm between fixings – doesn’t apply to outlets.
Fixings requirements for outlets
For outlets up to 200mm in diameter, four fixings are required, as illustrated above.
If an outlet is over 200mm in diameter, then six fixings must be used.
Order your bespoke moulded sole outlet
Developed as a specialist component to discharge water from the sole of the gutter, this item forms part of many successful Plygene gutterline system installations.
To order your required quantity, simply download and complete the attached PDF document with your project dimensions, job reference and number needed.
Function: To discharge water from the sole of the gutter
Type: Datasheets
