Bespoke moulded stop end
Format: pdf
Bespoke moulded stop end (MWSE)
The liner should be pinned and fixed prior to hot air welding of the stop end.
The angle is blank pinned and fixed after the hot air welding of the stop end.
Fixings specification engineered for gutter substrate type
| Substrate | Product Code | Pilot hole (if required) | Drill speed |
| STEEL < 3mm | HDS-LS-30 | N/A | 0-2000rpm – Can be full speed |
| STEEL > 3mm | HDS-HS-40 | N/A | 0-2000rpm – Can be full speed |
| CONCRETE | HDS-CON-45 | 5mm Diameter | 0-950rpm – Typically 750Watt |
| ASBESTOS | HDS-ASB-38 | 9.5mm Diameter | Set to lowest speed |
Remember, when drilling holes in asbestos cement and other highly bonded materials, to refer to the current health & safety guide.
The illustration shows a typical installation including four fasteners without washers and two fasteners with washers.
To determine how many fixings are required within pinning regions, the ‘200 rule’ should be always be followed.
The 200 rule
Put simply, the maximum permitted gap between fixings within the pinning region is 200mm.
For example, a 300mm gap between fixings should be bisected at 150mm (requiring one additional fixing) and a 600mm gap should be bridged with two additional fixings (one at 200mm and one at 400mm).
Order your bespoke moulded stop end
This component is a vital element of the Plygene gutterline system and plays an important role in ensuring rainwater is kept contained in the gutter.
To order your required quantity, simply download and complete the attached document with your project dimensions, job reference and number needed.
Function: To contain water in the gutter
Type: Datasheets
