Bespoke moulded vortex outlet
Format: pdf
Bespoke moulded vortex outlet (MWOV)
The liner should be pinned and fixed before any hot air welding of the vortex outlet occurs.
Fixings specification engineered for gutter substrate type
| Substrate | Product Code | Pilot hole (if required) | Drill speed |
| STEEL < 3mm | HDS-LS-30 | N/A | 0-2000rpm – Can be full speed |
| STEEL > 3mm | HDS-HS-40 | N/A | 0-2000rpm – Can be full speed |
| CONCRETE | HDS-CON-45 | 5mm Diameter | 0-950rpm – Typically 750Watt |
| ASBESTOS | HDS-ASB-38 | 9.5mm Diameter | Set to lowest speed |
Remember to refer to the current health & safety guide when drilling holes in highly bonded materials such as asbestos cement.
The usual ‘200 rule’ for bespoke moulded unit fixings doesn’t apply to outlets, which instead must comply with rules dependent on diameter.
Fixing requirements for outlets
For outlets of diameters up to and including 200mm, four fixings should be used, as illustrated above.
This requirement rises to six fixings for outlet diameters above 200mm.
Order your bespoke moulded vortex outlet
Offering a greater capacity than a standard sole outlet, this item is important in discharging water from many Plygene gutterline installations.
To order your required quantity, simply download and complete the attached document with your project dimensions, job reference and number needed.
Function: To give more capacity than a standard outlet
Type: Datasheets
